single-use aliquot raises a handful of sensible questions. This page answers them in order, starting with the fundamentals and moving to applications.
This page was last updated on 2025-12-18 and is reviewed periodically as new material appears.
Semax is normally supplied as a lyophilized powder, and that form is the most stable. Suppliers commonly recommend storage at -20 °C in a desiccated container protected from light, with short-term handling at room temperature limited to weighing and transfer. Powder that has absorbed moisture degrades faster, so vials should be warmed to ambient temperature before opening to prevent condensation on the contents. Hygroscopic behavior is typical of short hydrophilic peptides, and humidity control matters more than temperature alone for long-term retention.
Once dissolved, the peptide is considerably less stable than the solid. Aqueous solutions are usually prepared at neutral to slightly acidic pH, filtered, and divided into single-use aliquots before freezing. Repeated freeze-thaw cycles are a common cause of avoidable loss and are best prevented by never refreezing a thawed aliquot. Adsorption to plastic and glass surfaces can lower the measured concentration of dilute solutions, particularly below roughly 0.1 mg/mL. Buffer choice, salt content, and container material all influence how much peptide remains detectable after storage.
Identity and purity are established with standard peptide methods. Reversed-phase HPLC with ultraviolet detection near 214 nm resolves the parent peak from deletion and truncation byproducts, and reports typically quote a main-peak percentage. Mass spectrometry by electrospray or MALDI-TOF confirms the expected molecular mass, while amino acid analysis or peptide mapping can verify composition when the sequence itself is in question. A certificate of analysis that pairs a chromatogram with a mass spectrum is more informative than a purity figure alone. Counter-ion content and residual solvents are separate specifications and are frequently omitted.
Identity and purity of semax are established with reversed-phase high-performance liquid chromatography coupled to ultraviolet detection, usually at 214 nanometres. Mass spectrometry, most often electrospray ionisation in positive mode, confirms the molecular mass and reveals truncated sequences. Amino acid analysis and peptide mapping after enzymatic digestion provide additional structural confirmation. Laboratories typically report purity as the percentage area of the main peak, a figure that does not capture isomeric or oxidised variants unless the method resolves them.
The peptide is prone to several degradation pathways. Oxidation of the methionine residue produces a sulfoxide that elutes close to the parent peak in many chromatographic systems. Hydrolysis of peptide bonds and deamidation of susceptible residues in related sequences also reduce purity over time. Lyophilised material kept dry at minus twenty degrees Celsius and shielded from light is the most stable form commonly described in laboratory practice.
| Property | Value | Notes |
|---|---|---|
| Solid storage temperature | -20 °C or below | Desiccated and protected from light |
| Solution storage temperature | -80 °C as single-use aliquots | Avoid repeated freeze-thaw cycles |
| Purity assessment method | RP-HPLC, around 214 nm | Reported as main-peak area percent |
| Identity confirmation method | ESI-MS or MALDI-TOF | Measured mass compared with calculated mass |
| Common synonyms | ACTH(4-10) analog; Met-Glu-His-Phe-Pro-Gly-Pro | Also written as Semaxum in some sources |
=== Biochemistry === Iron acquisition poses a problem for aerobic organisms because ferric iron is poorly soluble near neutral pH. Thus, these organisms have developed means to absorb iron as complexes, sometimes taking up ferrous iron before oxidising it back to ferric iron. In particular, bacteria have evolved very high-affinity sequestering agents called siderophores. After uptake in human cells, iron storage is precisely regulated. A major component of this regulation is the protein transferrin, which binds iron ions absorbed from the duodenum and carries it in the blood to cells. Transferrin contains Fe3+ in the middle of a distorted octahedron, bonded to one nitrogen, three oxygens and a chelating carbonate anion that traps the Fe3+ ion: it has such a high stability constant that it is very effective at taking up Fe3+ ions even from the most stable complexes. At the bone marrow, transferrin is reduced from Fe3+ to Fe2+ and stored as ferritin to be incorporated into hemoglobin. The most commonly known and studied bioinorganic iron compounds (biological iron molecules) are the heme proteins: examples are hemoglobin, myoglobin, and cytochrome P450. These compounds participate in transporting gases, building enzymes, and transferring electrons. Metalloproteins are a group of proteins with metal ion cofactors. Some examples of iron metalloproteins are ferritin and rubredoxin. Many enzymes vital to life contain iron, such as catalase, lipoxygenases, and IRE-BP.
=== Differential diagnosis === IBM is often initially misdiagnosed as polymyositis. A course of prednisone is typically completed with no improvement and eventually, sIBM is confirmed. sIBM weakness comes on over months or years and progresses steadily, whereas polymyositis has an onset of weeks or months. Muscular dystrophy (e.g., limb girdle muscular dystrophy) must be considered as well. sIBM can be mistaken for physical deconditioning. Hereditary myopathies can mimic sIBM, both in signs and symptoms and in the appearance of muscle biopsies. A small percentage of those initially diagnosed with sIBM are later found to have pathogenic mutations in the genes VCP and SQSTM1, which are known to cause hIBM. IBM has a distinctive pattern of muscle involvement that distinguishes it among inflammatory myopathies. Characteristic of IBM is weakness of finger flexion, knee extension, and ankle dorsiflexion. Other inflammatory myopathies cause a proximal muscle weakness pattern, such as weakness of hip flexion, abduction, and extension, as well as shoulder abduction. IBM and other inflammatory myopathies both cause bicep/tricep weakness.
=== Prosecution in Panama === Noriega was tried in absentia in Panama for crimes committed during his rule. In October 1993 Noriega and two others were convicted of the murder of Spadafora by the court of the Third Judicial District, and sentenced to 20 years in prison. Panama's Supreme Court confirmed the sentence on December 20, 1995. In 1994, Noriega and Heráclides Sucre, an agent of his secret police, were convicted by a jury of the murder of Giroldi, who had led the 1989 coup attempt against Noriega. Though Noriega was tried in absentia, a judge traveled to the U.S. to question him in December 1993. Noriega and Sucre both received a 20-year sentence, the maximum penalty sought by the prosecutor. Finally, Noriega received a third 20-year sentence in 1996 for his role in the death of nine military officers supporting Giroldi; the group had been executed in a hangar at the Albrook air base after the coup attempt, in an incident that came to be known as the massacre of Albrook. Noriega was also prosecuted over the 1968 disappearances of Luis Antonio Quirós and Everett Clayton Kimble Guerra in Chiriquí, and the 1971 death of Heliodoro Portugal. These cases had not reached a conclusion at the time of his death in 2017.
Sources: en.wikipedia.org
Chondrocytes can be prepared by sequential enzymatic digestion of cartilage with Pronase and Collagenase and cultured in DMEM-F12 cell culture media. Transplantation of dedifferentiated chondrocytes often leads to the formation of fibrous tissue formation. Redifferentiation of dedifferentiated chondrocytes in the 3-D system (spheroid culture) restore morphological and functional properties. Carticel is a procedure for restoring articular knee cartilage with autologous chondrocyte implantation; it was the first cell therapy to be approved by the U.S. Food and Drug Administration, under accelerated approval in 1997. In Australia, Ortho-ACI, a suspension of cultured autologous chondrocytes, is indicated for use in the treatment of cartilage lesions associated with the knee, patella, and ankle. Chondronectin Endochondral ossification Intramembranous ossification List of human cell types derived from the germ layers List of distinct cell types in the adult human body Histology image: 03317loa – Histology Learning System at Boston University Stem cell information
Actinides easily react with halogens forming salts with the formulas MX3 and MX4 (X = halogen). So the first berkelium compound, BkCl3, was synthesized in 1962 with an amount of 3 nanograms. Like the halogens of rare earth elements, actinide chlorides, bromides, and iodides are water-soluble, and fluorides are insoluble. Uranium easily yields a colorless hexafluoride, which sublimates at a temperature of 56.5 °C; because of its volatility, it is used in the separation of uranium isotopes with gas centrifuge or gaseous diffusion. Actinide hexafluorides have properties close to anhydrides. They are very sensitive to moisture and hydrolyze forming AnO2F2. The pentachloride and black hexachloride of uranium were synthesized, but they are both unstable. Action of acids on actinides yields salts, and if the acids are non-oxidizing then the actinide in the salt is in low-valence state:
== Metabolism == Gliclazide undergoes extensive metabolism to several inactive metabolites in human beings, mainly methylhydroxygliclazide and carboxygliclazide. CYP2C9 is involved in the formation of hydroxygliclazide in human liver microsomes and in a panel of recombinant human P450s in vitro. But the pharmacokinetics of gliclazide MR are affected mainly by CYP2C19 genetic polymorphism instead of CYP2C9 genetic polymorphism.
=== Biodegradation === Because of the volume of surfactants released into the environment, for example laundry detergents in waters, their biodegradation is of great interest. Attracting much attention is the non-biodegradability and extreme persistence of fluorosurfactant, e.g. perfluorooctanoic acid (PFOA). Strategies to enhance degradation include ozone treatment and biodegradation. Two major surfactants, linear alkylbenzene sulfonates (LAS) and the alkyl phenol ethoxylates (APE) break down under aerobic conditions found in sewage treatment plants and in soil to nonylphenol, which is thought to be an endocrine disruptor. Interest in biodegradable surfactants has led to much interest in "biosurfactants" such as those derived from amino acids. Biobased surfactants can offer improved biodegradation. However, whether surfactants damage the cells of fish or cause foam mountains on bodies of water depends primarily on their chemical structure and not on whether the carbon originally used came from fossil sources, carbon dioxide or biomass.
Sources: en.wikipedia.org
Each freeze-thaw cycle can degrade a fraction of the peptide and promote aggregation. Dividing a stock solution into single-use volumes removes repeated cycling as a variable. It also limits the time a thawed solution spends at room temperature.
A high main-peak percentage says little about identity, counter-ion content, or residual solvents. It also does not distinguish an isomer or a closely eluting analog. Mass confirmation and the accompanying documentation cover those gaps.
Salt form changes mass, solubility, and hygroscopicity, and acetate and trifluoroacetate salts behave differently in solution. Storage guidance still centers on -20 °C for powder and lower temperatures for solutions. The certificate should state which salt is present.
Reversed-phase high-performance liquid chromatography is the standard method, with detection in the ultraviolet range. Peak area percentage yields a purity figure for the main component. Mass spectrometry is normally run alongside to confirm molecular identity.