certificate of analysis comes up often in conversation and rarely with the context attached. Here we lay out the basics in order, then work through the practical considerations.
Last reviewed on 2026-08-01. Where a claim depends on a specific study, the study is described rather than over-claimed.
Solid-phase peptide synthesis can produce truncated sequences when coupling reactions fail. Deletion peptides lack one or more internal residues, while truncation peptides end prematurely. Side reactions include aspartimide formation, oxidation of methionine, and aggregation during chain assembly. Crude synthetic peptides therefore contain target peptide plus related impurities, counterions, residual solvents, and water. Purification by preparative chromatography reduces these impurities but does not remove every closely related species, including some that differ by a single amino acid.
Quality control specifications for peptides typically include appearance, identity, purity by RP-HPLC, water content, counterion content, and residual trifluoroacetic acid. Karl Fischer titration measures water, while ion chromatography or elemental analysis can quantify counterions. Purity specifications may be set at 95% or 98% area percent, but the appropriate threshold depends on the application. For research reagents, a lower purity may be acceptable if identity is confirmed. For assays sensitive to impurities, higher purity and orthogonal testing are often required.
Handling and storage influence measured purity, and peptides can oxidize, deamidate, aggregate, or adsorb to surfaces over time. Lyophilized powders stored at -20 °C or lower are generally more stable than solutions, though some sequences require different conditions. Repeated freeze-thaw cycles can promote aggregation and loss, so testing after storage checks whether purity has changed. Stability-indicating methods compare stressed and unstressed samples to detect degradation pathways. Light exposure and pH can also accelerate modification.
Purity results are only meaningful when linked to a defined sample and method. A certificate of analysis typically lists the analytical technique, column type, gradient, detection wavelength, and integration parameters. It may also report mass confirmation, water content, and counterion composition. For research peptides, laboratories often request the raw chromatogram rather than only a summary percentage. This allows independent review of baseline, peak shape, and any unresolved shoulders that might be missed by a single number.
Stability testing examines how purity changes under controlled conditions. Samples are stored at defined temperatures, such as -20 °C or -80 °C, and analyzed at intervals. Lyophilized powders are generally more stable than solutions because water promotes hydrolysis and aggregation. Repeated freeze-thaw cycles can also degrade peptides, especially those with oxidation-prone residues. Accelerated studies at elevated temperature provide useful comparisons, but they do not always predict long-term behavior at lower temperatures.
Handling practices influence measured purity. Peptides may adsorb to plastic or glass surfaces, particularly when hydrophobic or positively charged. Weighing hygroscopic powders can introduce water and alter concentration. Dissolving in appropriate solvents and using low-binding tubes can reduce losses. Each laboratory should validate its own procedures because recovery and stability vary with peptide sequence, formulation, and container material. Open questions remain about how best to standardize stability reporting across different peptide classes.
| Property | Value | Notes |
|---|---|---|
| Typical purity specification | ≥95% by RP-HPLC | Common for research-grade material; some assays require 98% or higher. |
| Water content | 5–10% w/w | Lyophilized peptides retain moisture; Karl Fischer titration measures it. |
| Counterion | Trifluoroacetate or acetate | Counterion identity affects mass balance and assay compatibility. |
| Storage temperature | -20 °C or lower | Store desiccated and protected from light; avoid repeated freeze-thaw. |
| Common impurity | Deletion or truncation peptide | Similar sequence complicates chromatographic separation. |
For each diprotic acid titration curve, from left to right, there are two midpoints, two equivalence points, and two buffer regions. Due to the successive dissociation processes, there are two equivalence points in the titration curve of a diprotic acid. The first equivalence point occurs when all first protons from the first ionization are titrated. In other words, the amount of OH− added equals the original amount of H2A at the first equivalence point. The second equivalence point occurs when all protons are titrated. Therefore, the amount of OH− added equals twice the amount of H2A at this time. For a weak diprotic acid titrated by a strong base, the second equivalence point must occur at pH above 7 due to the hydrolysis of the resulted salts in the solution. At either equivalence point, adding a drop of base will cause the steepest rise of the pH value in the system.
The Bergmann degradation is a series of chemical reactions designed to remove a single amino acid from the carboxylic acid (C-terminal) end of a peptide. First demonstrated by Max Bergmann in 1934, it is a rarely used method for sequencing peptides. The later developed Edman degradation is an improvement upon the Bergmann degradation, instead cleaving the N-terminal amino acid of peptides to produce a hydantoin containing the desired amino acid. The Bergmann degradation follows the earlier work of Bergmann and his close colleague Leonidas Zervas, combining the organic azide degradation of the Curtius rearrangement with the Bergmann-Zervas carbobenzoxy method, which they designed to occur under relatively mild conditions so as to allow peptide sequencing. A single round of the Bergmann degradation yields an aldehyde containing the sought after amino acid residue and the remaining fragment of the original peptide in amide form.
Proteomics permits the quantitative analysis and detection of changes to proteins or protein biomarkers. Protein biomarkers detect a variety of biological changes, such as protein-protein interactions, post-translational modifications and immunological responses. Protein biomarkers are widely used in diagnostics due to their direct involvement in cellular functions and pathways. Protein biomarkers can provide direct information about the functional state of cells and tissues, offering insights into disease mechanisms. Techniques such as mass spectrometry, immunohistochemistry, ELISA, and flow cytometry are employed to detect protein biomarkers, which can indicate protein presence and quantification. For example, in about 20% of breast cancers, the cancer cells have an overexpression of the HER2 gene, leading to more aggressive tumor growth. HER2 status can be determined using IHC and FISH. HER2-positive breast cancers are treated with targeted therapies that specifically target the HER2 protein, inhibiting the growth of cancer cells.
Sources: en.wikipedia.org
AST is similar to alanine transaminase (ALT) in that both enzymes are associated with liver parenchymal cells. The difference is that ALT is found predominantly in the liver, with clinically negligible quantities found in the kidneys, heart, and skeletal muscle, while AST is found in the liver, heart (cardiac muscle), skeletal muscle, kidneys, brain, and red blood cells. As a result, ALT is a more specific indicator of liver inflammation than AST, as AST may be elevated also in diseases affecting other organs, such as myocardial infarction, acute pancreatitis, acute hemolytic anemia, severe burns, acute renal disease, musculoskeletal diseases, and trauma. The elevated AST level in hemorrhagic fever caused by crimean-congo hemorrhagic fever virus is associated with high mortality rate. AST was defined as a biochemical marker for the diagnosis of acute myocardial infarction in 1954. However, the use of AST for such a diagnosis is now redundant and has been superseded by the cardiac troponins. Laboratory tests should always be interpreted using the reference range from the laboratory that performed the test. Example reference ranges are shown below:
Azurin is a small, periplasmic, bacterial blue copper protein found in Pseudomonas, Bordetella, or Alcaligenes bacteria. Azurin moderates single-electron transfer between enzymes associated with the cytochrome chain by undergoing oxidation-reduction between Cu(I) and Cu(II). Each monomer of an azurin tetramer has a molecular weight of approximately 14kDa, contains a single copper atom, is intensively blue, and has a fluorescence emission band centered at 308 nm. Azurins and pseudoazurins participate in the denitrification processes in bacteria., including the gram-negative bacteria Pseudomonas aeruginosa, by interacting with cytochrome c551. Azurin from P aeruginosa is a type I blue copper protein (cupredoxin), while cytochrome c551 (9 kDa) is a haem-containing cytochrome. Azurin possesses a relatively large hydrophobic patch close to the active site, and two residues in this hydrophobic patch, Met-44 and Met-64, are believed to be involved in its interaction with the redox partners cytochrome c551 and nitrite reductase. Although unrelated to its electron-transfer property, azurin has been found to have anticancer properties through its interaction with tumor-suppressor protein p53.
Aspartate transaminase, as with all transaminases, operates via dual substrate recognition; that is, it is able to recognize and selectively bind two amino acids (Asp and Glu) with different side-chains. In either case, the transaminase reaction consists of two similar half-reactions that constitute what is referred to as a ping-pong mechanism. In the first half-reaction, amino acid 1 (e.g., L-Asp) reacts with the enzyme-PLP complex to generate ketoacid 1 (oxaloacetate) and the modified enzyme-PMP. In the second half-reaction, ketoacid 2 (α-ketoglutarate) reacts with enzyme-PMP to produce amino acid 2 (L-Glu), regenerating the original enzyme-PLP in the process. Formation of a racemic product (D-Glu) is very rare. The specific steps for the half-reaction of enzyme-PLP + aspartate ⇌ {\displaystyle \rightleftharpoons } enzyme-PMP + oxaloacetate are as follows (see figure); the other half-reaction (not shown) proceeds in the reverse manner, with α-ketoglutarate as the substrate.
Sources: en.wikipedia.org
Pseudoacromegaly is a condition with the usual acromegaloid features but without an increase in growth hormone and IGF-1. It is frequently associated with insulin resistance. Cases have been reported due to minoxidil at an unusually high dose. It can also be caused by a selective post-receptor defect of insulin signalling, leading to the impairment of metabolic, but preservation of mitogenic, signaling. Treatment options include surgery to remove the tumor, medications, and radiation therapy. Surgery is usually the preferred treatment; the smaller the tumor, the more likely surgery will be curative. If surgery is contraindicated or not curative, somatostatin analogues or GH receptor antagonists may be used. Radiation therapy may be used if neither surgery nor medications are completely effective. Without treatment, life expectancy is reduced by 10 years; with treatment, life expectancy is not reduced.
In the most common means for its production, cells make 5-oxo-ETE in a four step pathway that involves their stimulus-induced activation of the following pathway: a) the release of arachidonic acid (i.e. 5Z,8Z,11Z,14Z-eicosatetraenoic acid) from its storage sites in membrane phospholipids due to the activation of phospholipase A2 enzymes; b) oxygenation of this arachidonic acid by activated arachidonate 5-lipoxygenase (ALOX5) to form 5(S)-hydroperoxy-6E,8Z,11Z,14Z-eicosatetraenoic acid (5(S)-HpETE); c) reduction of this 5(S)-HpETE by ubiquitous cellular peroxidases to form 5(S)-hydroxy-6E,8Z,11Z,14Z-eicosatetraenoic acid (5(S)-HETE); and (d) the oxidation of 5(S)-HETE by a microsome-bound nicotinamide adenine dinucleotide phosphate (NADP+)-dependent dehydrogenase enzyme viz., 5-hydroxyeicosanoid dehydrogenase (5-HEDH), to form 5-oxo-ETE:
The Japan Transport Safety Board investigates aviation accidents and incidents. The Aircraft Accident Investigation Commission investigated aviation accidents and incidents in Japan until October 1, 2001, when the Aircraft and Railway Accidents Investigation Commission (ARAIC) replaced it, and the ARAIC did this function until October 1, 2008, when it merged into the JTSB. Established in 2016, the Air Accident Investigation Bureau (AAIB) Malaysia is the main investigation body for aircraft accident/incident. Separate from Civil Aviation Authority of Malaysia (CAAM) and Malaysian Aviation Commission (MAVCOM) that is the national aviation authority and commission that oversee aviation economy respectively. The AAIB operates from the ministry of transport headquarters in Putrajaya, and its black box laboratory situated in STRIDE, the ministry of defenses research institute. AAIB Malaysia is teamed by civilians and seconded Royal Malaysian Airforce senior officer and a group of pool investigators from Malaysia Institute of Aviation Technology
The latest development in the medical treatment of acromegaly is the use of growth hormone receptor antagonists. The only available member of this family is pegvisomant (Somavert). By blocking the action of the endogenous growth hormone molecules, this compound is able to control the disease activity of acromegaly in virtually everyone with acromegaly. Pegvisomant has to be administered subcutaneously by daily injections. Combinations of long-acting somatostatin analogues and weekly injections of pegvisomant seem to be equally effective as daily injections of pegvisomant. Paltusotine (Palsonify) was approved for medical use in the United States in September 2025.
Sources: en.wikipedia.org
No. Purity testing measures chemical composition and does not assess biological activity, sterility, or endotoxin levels. Functional performance must be tested in the intended assay.
Water adds mass and can affect concentration calculations. A peptide labeled 95% pure may contain water and counterions that reduce the actual peptide content.
Identity can be checked by mass spectrometry, and purity by RP-HPLC. Store according to supplier instructions and retest if experimental performance changes.
It typically includes the peptide sequence, molecular mass, purity method and result, storage recommendations, and date of analysis. Raw chromatograms and mass spectra may be provided on request. The absence of method details makes a purity value difficult to interpret.