lyophilised powder comes up often in conversation and rarely with the context attached. Here we lay out the basics in order, then work through the practical considerations.
Last reviewed on 2025-09-30. Where a claim depends on a specific study, the study is described rather than over-claimed.
Once dissolved, the peptide is considerably less stable than the solid. Aqueous solutions are usually prepared at neutral to slightly acidic pH, filtered, and divided into single-use aliquots before freezing. Repeated freeze-thaw cycles are a common cause of avoidable loss and are best prevented by never refreezing a thawed aliquot. Adsorption to plastic and glass surfaces can lower the measured concentration of dilute solutions, particularly below roughly 0.1 mg/mL. Buffer choice, salt content, and container material all influence how much peptide remains detectable after storage.
Identity and purity are established with standard peptide methods. Reversed-phase HPLC with ultraviolet detection near 214 nm resolves the parent peak from deletion and truncation byproducts, and reports typically quote a main-peak percentage. Mass spectrometry by electrospray or MALDI-TOF confirms the expected molecular mass, while amino acid analysis or peptide mapping can verify composition when the sequence itself is in question. A certificate of analysis that pairs a chromatogram with a mass spectrum is more informative than a purity figure alone. Counter-ion content and residual solvents are separate specifications and are frequently omitted.
Semax is normally supplied as a lyophilized powder, and that form is the most stable. Suppliers commonly recommend storage at -20 °C in a desiccated container protected from light, with short-term handling at room temperature limited to weighing and transfer. Powder that has absorbed moisture degrades faster, so vials should be warmed to ambient temperature before opening to prevent condensation on the contents. Hygroscopic behavior is typical of short hydrophilic peptides, and humidity control matters more than temperature alone for long-term retention.
Semax is a synthetic heptapeptide with the sequence Met-Glu-His-Phe-Pro-Gly-Pro. It corresponds to the ACTH(4-7) fragment extended at the C-terminus by a Pro-Gly-Pro tripeptide, an addition intended to slow enzymatic breakdown. The molecular formula is C37H51N9O10S and the molecular mass is approximately 814 daltons. In the literature it is often described as an ACTH(4-10) analog, although that label reflects a naming convention as much as a precise structural relationship. The compound was developed in Russia and remains most closely associated with that research tradition.
Laboratory descriptions of the material are consistent across suppliers. It appears as a white to off-white lyophilized powder that dissolves readily in water and in polar organic solvents such as dimethyl sulfoxide. Aqueous solutions are clear and colorless at low concentrations. Because the peptide contains methionine, oxidation at the sulfur atom is a recognized degradation pathway, and handling notes usually call for protected, desiccated storage. Reported purity for research-grade lots is generally above 95 percent as measured by reversed-phase high-performance liquid chromatography.
| Property | Value | Notes |
|---|---|---|
| Solid storage temperature | -20 °C or below | Desiccated and protected from light |
| Solution storage temperature | -80 °C as single-use aliquots | Avoid repeated freeze-thaw cycles |
| Purity assessment method | RP-HPLC, around 214 nm | Reported as main-peak area percent |
| Identity confirmation method | ESI-MS or MALDI-TOF | Measured mass compared with calculated mass |
| Common synonyms | ACTH(4-10) analog; Met-Glu-His-Phe-Pro-Gly-Pro | Also written as Semaxum in some sources |
Identity and purity are confirmed with reversed-phase high-performance liquid chromatography, typically monitored at 214 nanometres where the peptide bond absorbs. Mass spectrometry, either electrospray or MALDI-TOF, verifies molecular mass against the theoretical value and detects truncation or adduct formation. Amino acid analysis and peptide mapping provide additional confirmation when required. The most frequently reported impurities are deletion sequences from incomplete coupling, methionine sulfoxide from oxidation, and dimeric species formed through non-covalent aggregation. Impurity profiles depend strongly on the synthesis and purification route chosen by the producer.
Published research has focused mainly on neurological and cognitive endpoints in animal models, with proposed mechanisms involving brain-derived neurotrophic factor and related signalling pathways. A substantial share of the human data originates from a limited number of research groups, and independent replication in other countries remains sparse. Regulatory status reflects that distribution: the peptide is registered as a medicine in Russia and appears in some neighbouring markets, while elsewhere it is handled as a research chemical without approved therapeutic labelling. Questions about dose-response relationships, long-term effects, and comparability across studies are still open.
Lyophilised powder is normally kept at -20 °C in a desiccated container, with some suppliers recommending -80 °C for long-term archival storage. Repeated freeze-thaw cycles are the most common cause of avoidable loss, so aliquoting before freezing reduces variability between working sessions. Dissolved peptide is far less stable than the dry solid and is usually prepared fresh or held briefly at 4 °C. Aqueous solutions support both hydrolysis of the backbone and oxidation of the N-terminal methionine, and these two routes dominate degradation under ordinary laboratory conditions.
各国监管态度分化明显。俄罗斯按处方药管理，部分东欧国家留有使用记录；欧盟与美国未批准其作为药物上市，市面流通品通常标注为研究用化学品。身份差异意味着标示含量、纯度与无菌性缺少统一核查。体育领域还牵涉反兴奋剂名录，跨境携带则受目的地药品法规约束。
Semax 是人工设计的七肽，序列为 Met-Glu-His-Phe-Pro-Gly-Pro，骨架取自促肾上腺皮质激素片段 ACTH(4-10)。它于二十世纪八十年代在苏联的分子遗传学研究机构内合成。设计目标是保留该片段与注意力和记忆相关的活性，同时剔除促皮质激素释放等内分泌作用。此后俄罗斯将其登记为药品并进入临床使用。
当时的短肽研究普遍关注能否穿越血脑屏障、在低剂量下产生中枢效应，Semax 属于这一路线。鼻内给药是其主要使用方式，俄语文献报道的适应症涵盖缺血性卒中、短暂性脑缺血发作、认知功能减退以及视神经病变。这些研究大多发表在当地期刊上，样本规模与终点设置同西方试验惯例存在差异，国际同行对其临床证据的强度看法不一。
Dissolution is normally performed in water, phosphate-buffered saline, or normal saline, since the peptide is freely soluble in aqueous media and is rarely handled with strong organic solvents. Solution pH should be kept near neutral, because extreme acidity or alkalinity accelerates backbone hydrolysis and encourages oxidation of the methionine side chain. Once dissolved, the material is less stable than the dry powder and is commonly divided into single-use portions and frozen. Buffers containing primary amines, such as Tris, are often avoided because of possible side reactions.
Purity assessment relies mainly on reversed-phase high-performance liquid chromatography, which separates the target heptapeptide from truncated sequences, deletion analogues, and oxidised forms. Mass spectrometry, usually coupled to liquid chromatography, confirms identity through the expected molecular ion and reveals modifications such as methionine sulfoxide formation. Amino acid analysis can verify composition, and tandem mass spectrometry supports sequence confirmation. Ultraviolet detection near 254 to 280 nanometres is convenient because the phenylalanine and histidine residues absorb in that region. Nuclear magnetic resonance is rarely used for routine release testing.
Semax is a synthetic seven-amino-acid peptide whose sequence extends the ACTH(4-10) fragment with a C-terminal proline-glycine-proline tripeptide. The commonly cited sequence is Met-Glu-His-Phe-Pro-Gly-Pro, giving a molecular formula near C37H51N9O10S and a molecular weight close to 813.9 g/mol. It belongs to the broader class of synthetic ACTH fragments studied for central nervous system effects rather than for adrenal steroid stimulation. In practice the material appears as a lyophilized white powder for laboratory work or as a dilute saline solution in clinical settings.
Development is attributed to researchers at the Institute of Molecular Genetics in Moscow during the early 1980s, building on earlier Soviet work with ACTH fragments. Russian regulatory approval followed for intranasal use, and the compound has remained commercially available there for decades. Most published human data originate from Russian and, later, some Eastern European clinical reports, which are not always accessible in English translation. Outside that region the material is generally handled as a research chemical rather than a licensed medicine.
However, this vegetable is an alternative to wheat, the food base whose lack has caused shortages for centuries, which will lead to the Great Fear or an increase in the price of bread, such as it will be one of the popular reasons for the support of the people to the bourgeoisie during the French Revolution, the hungry crowd going to Versailles to get the "Boulanger" (Louis XVI), the "Boulangère" (Marie-Antoinette) and the "Petit Mitron" (the dauphin).
== Properties of organisms containing recombinant DNA == In most cases, organisms containing recombinant DNA have apparently normal phenotypes. That is, their appearance, behavior and metabolism are usually unchanged, and the only way to demonstrate the presence of recombinant sequences is to examine the DNA itself, typically using a polymerase chain reaction (PCR) test. Significant exceptions exist, and are discussed below. If the rDNA sequences encode a gene that is expressed, then the presence of RNA and/or protein products of the recombinant gene can be detected, typically using RT-PCR or western hybridization methods. Gross phenotypic changes are not the norm, unless the recombinant gene has been chosen and modified so as to generate biological activity in the host organism. Additional phenotypes that are encountered include toxicity to the host organism induced by the recombinant gene product, especially if it is over-expressed or expressed within inappropriate cells or tissues. In some cases, recombinant DNA can have deleterious effects even if it is not expressed. One mechanism by which this happens is insertional inactivation, in which the rDNA becomes inserted into a host cell's gene. In some cases, researchers use this phenomenon to "knock out" genes to determine their biological function and importance. Another mechanism by which rDNA insertion into chromosomal DNA can affect gene expression is by inappropriate activation of previously unexpressed host cell genes.
Neuropeptide SF (NPSF) (RFRP-1) – agonist of the NPFF1 and NPFF2 receptors (EC50 = 29 nM and 0.0011 nM, respectively) RFRP-2 – does not bind to either of the NPFF receptors; no known biological activity Neuropeptide VF (NPVF) (RFRP-3) – agonist of the NPFF1 receptor (IC50 = 0.7 nM) NPSF and NPVF, originally referred to as the RFamide-related peptides RFRP-1 and RFRP-3, respectively, are the mammalian homologs of the avian neuropeptide gonadotropin-inhibitory hormone (GnIH). The mammalian NPVF and avian GnIH genes, along with their aforementioned peptide products, were discovered concurrently in 2000. Similarly to the avian GnIH neuropeptide, NPSF and NPVF have been found to potently inhibit gonadotropin secretion. Moreover, a potent and selective antagonist of the NPFF receptors, RF9, has been reported to possess "very strong" gonadotropin-releasing effects in vivo in male and female mice.
Sources: en.wikipedia.org
== Pharmacokinetics == Prucalopride is rapidly absorbed (Cmax attained 2–3 hours after single 2 mg oral dose) and is extensively distributed. Metabolism is not the major route of elimination. In vitro, human liver metabolism is very slow and only minor amounts of metabolites are found. A large fraction of the active substance is excreted unchanged (about 60% of the administered dose in urine and at least 6% in feces). Renal excretion of unchanged prucalopride involves both passive filtration and active secretion. Plasma clearance averages 317 ml/min, terminal half-life is 24–30 hours, and steady-state is reached within 3–4 days. On once daily treatment with 2 mg prucalopride, steady-state plasma concentrations fluctuate between trough and peak values of 2.5 and 7 ng/ml, respectively. In vitro data indicate that prucalopride has a low interaction potential, and therapeutic concentrations of prucalopride are not expected to affect the CYP-mediated metabolism of co-medicated medicinal products.
Though phallotoxins are highly toxic to liver cells, they have since been found to add little to the death cap's toxicity, as they are not absorbed through the gut. Furthermore, phalloidin is also found in the edible (and sought-after) blusher (A. rubescens). Another group of minor active peptides are the virotoxins, which consist of six similar monocyclic heptapeptides. Like the phallotoxins, they do not induce any acute toxicity after ingestion in humans. The genome of the death cap has been sequenced.
=== Decay by two or more processes === Some quantities decay by two exponential-decay processes simultaneously. In this case, the actual half-life T½ can be related to the half-lives t1 and t2 that the quantity would have if each of the decay processes acted in isolation:
== Behavior informatics == Behavior informatics, also called behavior computing, explores behavior intelligence and behavior insights from the informatics and computing perspectives. Different from applied behavior analysis from the psychological perspective, behavior informatics builds computational theories, systems and tools to qualitatively and quantitatively model, represent, analyze, and manage behaviors of individuals, groups and/or organizations.
Sources: en.wikipedia.org
Each freeze-thaw cycle can degrade a fraction of the peptide and promote aggregation. Dividing a stock solution into single-use volumes removes repeated cycling as a variable. It also limits the time a thawed solution spends at room temperature.
A high main-peak percentage says little about identity, counter-ion content, or residual solvents. It also does not distinguish an isomer or a closely eluting analog. Mass confirmation and the accompanying documentation cover those gaps.
Salt form changes mass, solubility, and hygroscopicity, and acetate and trifluoroacetate salts behave differently in solution. Storage guidance still centers on -20 °C for powder and lower temperatures for solutions. The certificate should state which salt is present.
It is registered as a pharmaceutical product in Russia, where it is typically supplied as a nasal solution. In most other countries it is not an approved drug and is traded as a research chemical instead. Approval status depends entirely on the jurisdiction involved.