A practical reference on 反相色谱: what it is, how it behaves, what the literature reports, and where the honest uncertainties sit.
Reviewed 2025-11-27. Anything still debated is marked as such rather than presented as settled.
Semax is normally supplied as a lyophilized powder, and that form is the most stable. Suppliers commonly recommend storage at -20 °C in a desiccated container protected from light, with short-term handling at room temperature limited to weighing and transfer. Powder that has absorbed moisture degrades faster, so vials should be warmed to ambient temperature before opening to prevent condensation on the contents. Hygroscopic behavior is typical of short hydrophilic peptides, and humidity control matters more than temperature alone for long-term retention.
Once dissolved, the peptide is considerably less stable than the solid. Aqueous solutions are usually prepared at neutral to slightly acidic pH, filtered, and divided into single-use aliquots before freezing. Repeated freeze-thaw cycles are a common cause of avoidable loss and are best prevented by never refreezing a thawed aliquot. Adsorption to plastic and glass surfaces can lower the measured concentration of dilute solutions, particularly below roughly 0.1 mg/mL. Buffer choice, salt content, and container material all influence how much peptide remains detectable after storage.
Identity and purity are established with standard peptide methods. Reversed-phase HPLC with ultraviolet detection near 214 nm resolves the parent peak from deletion and truncation byproducts, and reports typically quote a main-peak percentage. Mass spectrometry by electrospray or MALDI-TOF confirms the expected molecular mass, while amino acid analysis or peptide mapping can verify composition when the sequence itself is in question. A certificate of analysis that pairs a chromatogram with a mass spectrum is more informative than a purity figure alone. Counter-ion content and residual solvents are separate specifications and are frequently omitted.
Dissolution is normally performed in water, phosphate-buffered saline, or normal saline, since the peptide is freely soluble in aqueous media and is rarely handled with strong organic solvents. Solution pH should be kept near neutral, because extreme acidity or alkalinity accelerates backbone hydrolysis and encourages oxidation of the methionine side chain. Once dissolved, the material is less stable than the dry powder and is commonly divided into single-use portions and frozen. Buffers containing primary amines, such as Tris, are often avoided because of possible side reactions.
Purity assessment relies mainly on reversed-phase high-performance liquid chromatography, which separates the target heptapeptide from truncated sequences, deletion analogues, and oxidised forms. Mass spectrometry, usually coupled to liquid chromatography, confirms identity through the expected molecular ion and reveals modifications such as methionine sulfoxide formation. Amino acid analysis can verify composition, and tandem mass spectrometry supports sequence confirmation. Ultraviolet detection near 254 to 280 nanometres is convenient because the phenylalanine and histidine residues absorb in that region. Nuclear magnetic resonance is rarely used for routine release testing.
| Property | Value | Notes |
|---|---|---|
| Solid storage temperature | -20 °C or below | Desiccated and protected from light |
| Solution storage temperature | -80 °C as single-use aliquots | Avoid repeated freeze-thaw cycles |
| Purity assessment method | RP-HPLC, around 214 nm | Reported as main-peak area percent |
| Identity confirmation method | ESI-MS or MALDI-TOF | Measured mass compared with calculated mass |
| Common synonyms | ACTH(4-10) analog; Met-Glu-His-Phe-Pro-Gly-Pro | Also written as Semaxum in some sources |
Semax is supplied as a lyophilized powder that appears white to off-white. It dissolves readily in water, phosphate-buffered saline, and other aqueous media, which simplifies preparation of working solutions for laboratory use. The nasal products registered in Russia are dilute aqueous solutions, typically around 0.1 percent peptide by weight. Organic solvents are rarely necessary and can complicate handling. Because the peptide is hygroscopic, weighing should be performed quickly and with minimal exposure to ambient humidity.
Solid material is normally kept at minus 20 degrees Celsius in a sealed, desiccated container. Reconstituted solutions are less stable and are usually divided into single-use aliquots before freezing. Repeated freeze-thaw cycles are avoided because they promote aggregation and loss of activity. Light exposure is minimized by using amber glassware or foil wrapping. Published stability data for this peptide are sparse, so recommended storage conditions rest mainly on general practice for short synthetic peptides rather than on dedicated study.
Material sold for laboratory use varies widely in stated purity and documentation. A certificate of analysis should list the analytical method, the column and detector used, and the observed purity value. Independent verification by an outside laboratory is the practical way to confirm identity when documentation is absent or internally inconsistent. Regulatory status differs by country, and a product legal in one jurisdiction may be unapproved or controlled in another.
Identity and purity of semax are established with reversed-phase high-performance liquid chromatography coupled to ultraviolet detection, usually at 214 nanometres. Mass spectrometry, most often electrospray ionisation in positive mode, confirms the molecular mass and reveals truncated sequences. Amino acid analysis and peptide mapping after enzymatic digestion provide additional structural confirmation. Laboratories typically report purity as the percentage area of the main peak, a figure that does not capture isomeric or oxidised variants unless the method resolves them.
The peptide is prone to several degradation pathways. Oxidation of the methionine residue produces a sulfoxide that elutes close to the parent peak in many chromatographic systems. Hydrolysis of peptide bonds and deamidation of susceptible residues in related sequences also reduce purity over time. Lyophilised material kept dry at minus twenty degrees Celsius and shielded from light is the most stable form commonly described in laboratory practice.
稳定性主要由水解与氧化两条路径支配。肽键在中性或弱酸性条件下相对稳定，遇到强碱或长时间高温则明显断裂；甲硫氨酸侧链容易被氧化成亚砜，使主峰前移并拉低实际含量。金属离子、光照和反复冻融会进一步促进降解或聚集。冻干粉在低温避光条件下可存放较长时间，配制后的水溶液通常需要冷藏并尽快用完。
纯度评估以反相高效液相色谱为主，通过主峰面积百分比给出粗略结果，再配合电喷雾质谱核对分子量。氨基酸分析可验证组成比例，手性色谱或毛细管电泳用于检查残基构型。常见杂质包括缺失序列的短肽、氧化产物与二聚体。由于多数市售品不附带完整检验报告，独立第三方检测常被用来核实标称值。
1993/584) National Blood Authority (Establishment and Constitution) Order 1993 (S.I. 1993/585) National Blood Authority Regulations 1993 (S.I. 1993/586) Central Blood Laboratories Authority (Revocation) Order 1993 (S.I. 1993/587) Nurses, Midwives and Health Visitors Act 1992 (Commencement No. 1) Order 1993 (S.I. 1993/588) Registration of Births, Deaths and Marriages (Fees) (Amendment) (No. 2) Order 1993 (S.I. 1993/589) United Kingdom Central Council for Nursing, Midwifery and Health Visiting (Term of Office of Members) Order 1993 (S.I. 1993/590) Recovery of Maintenance (United States of America) Order 1993 (S.I. 1993/591) Social Security (Northern Ireland) Order 1993 (S.I. 1993/592) Reciprocal Enforcement of Maintenance Orders (Hague Convention Countries) Order 1993 (S.I. 1993/593) Reciprocal Enforcement of Maintenance Orders (Republic of Ireland) Order 1993 (S.I. 1993/594) European Communities (Designation) Order 1993 (S.I. 1993/595) Veterinary Surgeons Qualifications (EEC Recognition) (Amendment) Order 1993 (S.I. 1993/596) Home Guard (Amendment) Order 1993 (S.I. 1993/597) Naval, Military and Air Forces etc. (Disablement and Death) Service Pensions Amendment Order 1993 (S.I. 1993/598) Continental Shelf (Designation of Areas) Order 1993 (S.I. 1993/599)
== Coordination chemistry and applications == The conjugate base of NTA is a tripodal tetradentate trianionic ligand, forming coordination compounds with a variety of metal ions. Like EDTA, its sodium salt is used for water softening to remove Ca2+. For this purpose, NTA is a replacement for triphosphate, which once was widely used in detergents, and cleansers, but can cause eutrophication of lakes. In one application, sodium NTA removes Cr, Cu, and As from wood that had been treated with chromated copper arsenate.
=== Structure === GsMTx-4 has a polypeptide chain of 35 amino acids with the sequence GCLEF-WWKCN-PNDDK-CCRPK-LKCSK-LFKLC-NFSF, the C-terminus is amidated. The toxin is an amphipathic peptide consisting of a large hydrophobic patch which is surrounded by a ring of six polar lysine residues. These hydrophobic residues enable the toxin to carry an overall charge of +5. The toxin contains three intramolecular disulfide bonds that contribute to the formation of its inhibitor cystine knot (ICK).
Sources: en.wikipedia.org
Reta Phyllis Mays (born June 16, 1975) is an American serial killer who murdered at least seven elderly military veterans over a span of eleven months, between July 2017 and June 2018, by injecting them with lethal doses of insulin while she was employed as a nursing assistant at the Louis A. Johnson Veterans Medical Center, in Clarksburg, West Virginia. On May 11, 2021, Mays was sentenced to seven consecutive life sentences for the murders, plus 20 years for one count of assault with intent to commit murder.
The first studies measuring drugs in biological fluids were carried out to determine possible overdosing as part of the new science of forensic medicine/toxicology. Initially, nonspecific assays were applied to measuring drugs in biological fluids. These were unable to discriminate between the drug and its metabolites; for example, aspirin (c. 1900) and sulfonamides (developed in the 1930s) were quantified by the use of colorimetric assays. Antibiotics were quantified by their ability to inhibit bacterial growth. The 1930s also saw the rise of pharmacokinetics, and as such the desire for more specific assays. Modern drugs are more potent, which has required more sensitive bioanalytical assays to accurately and reliably determine these drugs at lower concentrations. This has driven improvements in technology and analytical methods. Some techniques commonly used in bioanalytical studies include:
The adjacent figure shows a typical fission product distribution from the fission of uranium. Note that in the calculations used to make this graph, the activation of fission products was ignored and the fission was assumed to occur in a single moment rather than a length of time. In this bar chart results are shown for different cooling times (time after fission). Because of the stability of nuclei with even numbers of protons and/or neutrons, the curve of yield against element is not a smooth curve but tends to alternate. Note that the curve against mass number is smooth.
== History == Precursor drugs to repaglinide were invented in late 1983 by scientists at Dr Karl Thomae GmbH, a German drug manufacturer located at Biberach an der Riß in southern Germany which was acquired by Boehringer Ingelheim in 1990. The drug that became repaglinide was later licensed by Boehringer to Novo Nordisk, which filed an Investigational New Drug application for the compound with the Food and Drug Administration (FDA) in April 1992. Novo Nordisk filed its New Drug Application (NDA) for Prandin in July 1997 and it was quickly approved, gaining FDA approval in December 1997. The drug was the first of the meglitinide class. It was branded Prandin because its quick onset and short duration of action concentrates its effect around meal time (the prandium was the Roman meal which is comparable to the modern lunch).
Sources: en.wikipedia.org
Each freeze-thaw cycle can degrade a fraction of the peptide and promote aggregation. Dividing a stock solution into single-use volumes removes repeated cycling as a variable. It also limits the time a thawed solution spends at room temperature.
A high main-peak percentage says little about identity, counter-ion content, or residual solvents. It also does not distinguish an isomer or a closely eluting analog. Mass confirmation and the accompanying documentation cover those gaps.
Salt form changes mass, solubility, and hygroscopicity, and acetate and trifluoroacetate salts behave differently in solution. Storage guidance still centers on -20 °C for powder and lower temperatures for solutions. The certificate should state which salt is present.
Dry powder is usually kept at about -20 degrees Celsius for long-term storage and at 2 to 8 degrees Celsius for short working periods. Containers should stay sealed and protected from light and moisture to limit degradation.