This is a working overview of Oxidation, written for readers who want more than a one-paragraph summary but less than a textbook.
This page was last updated on 2026-05-23 and is reviewed periodically as new material appears.
Once dissolved, the peptide is considerably less stable than the solid. Aqueous solutions are usually prepared at neutral to slightly acidic pH, filtered, and divided into single-use aliquots before freezing. Repeated freeze-thaw cycles are a common cause of avoidable loss and are best prevented by never refreezing a thawed aliquot. Adsorption to plastic and glass surfaces can lower the measured concentration of dilute solutions, particularly below roughly 0.1 mg/mL. Buffer choice, salt content, and container material all influence how much peptide remains detectable after storage.
Identity and purity are established with standard peptide methods. Reversed-phase HPLC with ultraviolet detection near 214 nm resolves the parent peak from deletion and truncation byproducts, and reports typically quote a main-peak percentage. Mass spectrometry by electrospray or MALDI-TOF confirms the expected molecular mass, while amino acid analysis or peptide mapping can verify composition when the sequence itself is in question. A certificate of analysis that pairs a chromatogram with a mass spectrum is more informative than a purity figure alone. Counter-ion content and residual solvents are separate specifications and are frequently omitted.
Identity and purity of semax are established with reversed-phase high-performance liquid chromatography coupled to ultraviolet detection, usually at 214 nanometres. Mass spectrometry, most often electrospray ionisation in positive mode, confirms the molecular mass and reveals truncated sequences. Amino acid analysis and peptide mapping after enzymatic digestion provide additional structural confirmation. Laboratories typically report purity as the percentage area of the main peak, a figure that does not capture isomeric or oxidised variants unless the method resolves them.
The peptide is prone to several degradation pathways. Oxidation of the methionine residue produces a sulfoxide that elutes close to the parent peak in many chromatographic systems. Hydrolysis of peptide bonds and deamidation of susceptible residues in related sequences also reduce purity over time. Lyophilised material kept dry at minus twenty degrees Celsius and shielded from light is the most stable form commonly described in laboratory practice.
| Property | Value | Notes |
|---|---|---|
| Solid storage temperature | -20 °C or below | Desiccated and protected from light |
| Solution storage temperature | -80 °C as single-use aliquots | Avoid repeated freeze-thaw cycles |
| Purity assessment method | RP-HPLC, around 214 nm | Reported as main-peak area percent |
| Identity confirmation method | ESI-MS or MALDI-TOF | Measured mass compared with calculated mass |
| Common synonyms | ACTH(4-10) analog; Met-Glu-His-Phe-Pro-Gly-Pro | Also written as Semaxum in some sources |
== History == In 1997, Hong Kong molecular biologist Dennis Lo and his team first employed the Y-PCR assay to identify fetal Y chromosome sequences (because Y-specific sequences are genetic sequences of the fetus not in the maternal genome) in maternal plasma samples. For this groundbreaking work, Lo was honored with the 2022 Lasker DeBakey Clinical Medical Research Award.
=== Mechanism of action === Posaconazole works by disrupting the functions of certain fungal and protozoal membrane-bound enzyme systems. It does this by blocking the synthesis and turnover of the eukaryotic cell membrane component ergosterol via the inhibition of an enzyme known as CYP51. Posaconazole is significantly more potent at binding to CYP51 than itraconazole.
== Scarcity == Sea cucumbers in the waters of Malaysia have been over-harvested to supply consumers of the folk remedy, and as a result the animal and its products are becoming scarce. Efforts to restock the fishery have not generally been successful. Recently, a sea cucumber aquaculture operation was opened on the shores of several Malaysian islands to increase the gamat supply.
Sources: en.wikipedia.org
=== From organic halides and cyanide salts === Two salt metathesis reactions are popular for laboratory scale reactions. In the Kolbe nitrile synthesis, alkyl halides undergo nucleophilic aliphatic substitution with alkali metal cyanides. Aryl nitriles are prepared in the Rosenmund-von Braun synthesis. In general, metal cyanides combine with alkyl halides to give a mixture of the nitrile and the isonitrile, although appropriate choice of counterion and temperature can minimize the latter. An alkyl sulfate obviates the problem entirely, particularly in nonaqueous conditions (the Pelouze synthesis). In the Kolbe nitrile synthesis (a nucleophilic substitution reaction), an alkanonitrile and an alkali halide are formed from a reactive halocarbons and an alkali cyanide (sodium cyanide or potassium cyanide). The reaction is particularly suitable for primary, allylic, and benzylic halides. Secondary alkyl halides provide lower yields, whereas tertiary halides undergo exclusively elimination reaction instead of substitution. In addition to halides, substrates bearing other good leaving groups may also be employed. In contrast to alkali cyanides, silver cyanide is unsuitable for nitrile synthesis, as it preferentially forms isonitriles. An example of the Kolbe nitrile synthesis is the reaction of methyl iodide with sodium cyanide to yield acetonitrile and sodium iodide:
When cells divide, their full genome is copied and each daughter cell inherits one copy. This process, called mitosis, is the simplest form of reproduction and is the basis for asexual reproduction. Asexual reproduction can also occur in multicellular organisms, producing offspring that inherit their genome from a single parent. Offspring that are genetically identical to their parents are called clones. Eukaryotic organisms often use sexual reproduction to generate offspring that contain a mixture of genetic material inherited from two different parents. The process of sexual reproduction alternates between forms that contain single copies of the genome (haploid) and double copies (diploid). Haploid cells fuse and combine genetic material to create a diploid cell with paired chromosomes. Diploid organisms form haploids by dividing, without replicating their DNA, to create daughter cells that randomly inherit one of each pair of chromosomes. Most animals and many plants are diploid for most of their lifespan, with the haploid form reduced to single cell gametes such as sperm or eggs. Although they do not use the haploid/diploid method of sexual reproduction, bacteria have many methods of acquiring new genetic information. Some bacteria can undergo conjugation, transferring a small circular piece of DNA to another bacterium. Bacteria can also take up raw DNA fragments found in the environment and integrate them into their genomes, a phenomenon known as transformation.
=== 1950s === 1954: Jack Bush purchases the rights to a new membrane-production process developed by Lovell Chemical Company. Millipore Filter Corporation is incorporated and Bush becomes president, and later chairman 1955: Millipore receives its first patent, for microporous nylon film invented by Stanley Lovell and Jack Bush
=== Arnold Adolph Berthold (1849) === Arnold Adolph Berthold was a German physiologist and zoologist, who, in 1849, had a question about the function of the testes. He noticed in castrated roosters that they did not have the same sexual behaviors as roosters with their testes intact. He decided to run an experiment on male roosters to examine this phenomenon. He kept a group of roosters with their testes intact, and saw that they had normally sized wattles and combs (secondary sexual organs), a normal crow, and normal sexual and aggressive behaviors. He also had a group with their testes surgically removed, and noticed that their secondary sexual organs were decreased in size, had a weak crow, did not have sexual attraction towards females, and were not aggressive. He realized that this organ was essential for these behaviors, but he did not know how. To test this further, he removed one testis and placed it in the abdominal cavity. The roosters acted and had normal physical anatomy. He was able to see that the location of the testes does not matter. He then wanted to see if it was a genetic factor that was involved in the testes that provided these functions. He transplanted a testis from another rooster to a rooster with one testis removed, and saw that they had normal behavior and physical anatomy as well. Berthold determined that the location or genetic factors of the testes do not matter in relation to sexual organs and behaviors, but that some chemical in the testes is being secreted is causing this phenomenon.
Sources: en.wikipedia.org
Each freeze-thaw cycle can degrade a fraction of the peptide and promote aggregation. Dividing a stock solution into single-use volumes removes repeated cycling as a variable. It also limits the time a thawed solution spends at room temperature.
A high main-peak percentage says little about identity, counter-ion content, or residual solvents. It also does not distinguish an isomer or a closely eluting analog. Mass confirmation and the accompanying documentation cover those gaps.
Salt form changes mass, solubility, and hygroscopicity, and acetate and trifluoroacetate salts behave differently in solution. Storage guidance still centers on -20 °C for powder and lower temperatures for solutions. The certificate should state which salt is present.
Reversed-phase high-performance liquid chromatography is the standard method, with detection in the ultraviolet range. Peak area percentage yields a purity figure for the main component. Mass spectrometry is normally run alongside to confirm molecular identity.