If you have been reading about ACTH 片段 and want a single page that covers the useful parts, this is it: definitions, context, how it is studied, and the questions that come up repeatedly.
Updated 2025-12-24. Numbers and descriptions here follow the published literature rather than marketing material.
Identity and purity of semax are established with reversed-phase high-performance liquid chromatography coupled to ultraviolet detection, usually at 214 nanometres. Mass spectrometry, most often electrospray ionisation in positive mode, confirms the molecular mass and reveals truncated sequences. Amino acid analysis and peptide mapping after enzymatic digestion provide additional structural confirmation. Laboratories typically report purity as the percentage area of the main peak, a figure that does not capture isomeric or oxidised variants unless the method resolves them.
The peptide is prone to several degradation pathways. Oxidation of the methionine residue produces a sulfoxide that elutes close to the parent peak in many chromatographic systems. Hydrolysis of peptide bonds and deamidation of susceptible residues in related sequences also reduce purity over time. Lyophilised material kept dry at minus twenty degrees Celsius and shielded from light is the most stable form commonly described in laboratory practice.
Material sold for laboratory use varies widely in stated purity and documentation. A certificate of analysis should list the analytical method, the column and detector used, and the observed purity value. Independent verification by an outside laboratory is the practical way to confirm identity when documentation is absent or internally inconsistent. Regulatory status differs by country, and a product legal in one jurisdiction may be unapproved or controlled in another.
Semax is a synthetic heptapeptide developed in the Soviet Union during the 1980s by researchers at the Institute of Molecular Genetics in Moscow. It was designed as a truncated analog of adrenocorticotropic hormone, retaining only the fragment spanning residues four through ten. Investigators sought a peptide that would preserve the cognitive effects associated with ACTH while eliminating the hormonal stimulation of the adrenal cortex. The compound entered clinical use in Russia during the following decade.
Russian regulatory authorities approved the peptide for nasal administration, and it remains listed in the national pharmacopoeia under several trade names. Documented indications include acute ischemic stroke, transient ischemic attacks, traumatic brain injury, and certain ophthalmological and neurological conditions. Physicians also prescribe it for cognitive complaints in older patients, although the evidence base for that use is thinner. Outside Russia and a few neighboring states, the substance is not an approved medicine and is sold instead as a research chemical.
| Property | Value | Notes |
|---|---|---|
| Appearance | White to off-white powder | Lyophilised solid |
| Solubility class | Freely soluble in water | Also dissolves in aqueous buffers |
| Typical storage temperature | -20 °C | Dry, desiccated, protected from light |
| Typical analytical method | RP-HPLC with UV detection | Often paired with LC-MS |
| Water content | Reported as Karl Fischer value | Freeze-dried material is hygroscopic |
Published studies examine a fairly narrow set of endpoints. Rodent experiments commonly measure maze learning, infarct volume after induced ischemia, and tissue levels of neurotrophic factors. Clinical reports from Russian centres describe attention, memory and recovery scores in patients after stroke or transient ischemic attack. Most of those human studies are small and few have been repeated by independent groups. Outcome measures differ between studies, which limits direct comparison.
Circulation time for the peptide is short because peptidases cleave it readily. The Pro-Gly-Pro tail is thought to slow breakdown compared with the bare ACTH fragment, but the gain appears modest. Absorption after intranasal dosing is limited, and only a fraction of a dose is expected to reach the central nervous system. Laboratory concentrations therefore sit well above levels achieved systemically, a gap that complicates translation from bench findings to clinical claims.
各国监管态度分化明显。俄罗斯按处方药管理，部分东欧国家留有使用记录；欧盟与美国未批准其作为药物上市，市面流通品通常标注为研究用化学品。身份差异意味着标示含量、纯度与无菌性缺少统一核查。体育领域还牵涉反兴奋剂名录，跨境携带则受目的地药品法规约束。
Semax 是人工设计的七肽，序列为 Met-Glu-His-Phe-Pro-Gly-Pro，骨架取自促肾上腺皮质激素片段 ACTH(4-10)。它于二十世纪八十年代在苏联的分子遗传学研究机构内合成。设计目标是保留该片段与注意力和记忆相关的活性，同时剔除促皮质激素释放等内分泌作用。此后俄罗斯将其登记为药品并进入临床使用。
当时的短肽研究普遍关注能否穿越血脑屏障、在低剂量下产生中枢效应，Semax 属于这一路线。鼻内给药是其主要使用方式，俄语文献报道的适应症涵盖缺血性卒中、短暂性脑缺血发作、认知功能减退以及视神经病变。这些研究大多发表在当地期刊上，样本规模与终点设置同西方试验惯例存在差异，国际同行对其临床证据的强度看法不一。
Identity and purity are established with standard peptide methods. Reversed-phase HPLC with ultraviolet detection near 214 nm resolves the parent peak from deletion and truncation byproducts, and reports typically quote a main-peak percentage. Mass spectrometry by electrospray or MALDI-TOF confirms the expected molecular mass, while amino acid analysis or peptide mapping can verify composition when the sequence itself is in question. A certificate of analysis that pairs a chromatogram with a mass spectrum is more informative than a purity figure alone. Counter-ion content and residual solvents are separate specifications and are frequently omitted.
Semax is normally supplied as a lyophilized powder, and that form is the most stable. Suppliers commonly recommend storage at -20 °C in a desiccated container protected from light, with short-term handling at room temperature limited to weighing and transfer. Powder that has absorbed moisture degrades faster, so vials should be warmed to ambient temperature before opening to prevent condensation on the contents. Hygroscopic behavior is typical of short hydrophilic peptides, and humidity control matters more than temperature alone for long-term retention.
All of the discovered alkali metals occur in nature as their compounds: in order of abundance, sodium is the most abundant, followed by potassium, lithium, rubidium, caesium, and finally francium, which is very rare due to its extremely high radioactivity; francium occurs only in minute traces in nature as an intermediate step in some obscure side branches of the natural decay chains. Experiments have been conducted to attempt the synthesis of element 119, which is likely to be the next member of the group; none were successful. However, ununennium may not be an alkali metal due to relativistic effects, which are predicted to have a large influence on the chemical properties of superheavy elements; even if it does turn out to be an alkali metal, it is predicted to have some differences in physical and chemical properties from its lighter homologues. Most alkali metals have many different applications. One of the best-known applications of the pure elements is the use of rubidium and caesium in atomic clocks, of which caesium atomic clocks form the basis of the second. A common application of the compounds of sodium is the sodium-vapour lamp, which emits light very efficiently. Table salt, or sodium chloride, has been used since antiquity. Lithium finds use as a psychiatric medication and as an anode in lithium batteries. Sodium, potassium and possibly lithium are essential elements, having major biological roles as electrolytes, and although the other alkali metals are not essential, they also have various effects on the body, both beneficial and harmful.
Specifically, two dimers, one cyclic (C6H12O4, a tetroxane) and one open chain (C6H14O4), as well as an open dihydroperoxide monomer (C3H8O4), can also be formed; under a particular set of conditions of reagent and acid catalyst concentration, the cyclic trimer is the primary product. Under neutral conditions, the reaction is reported to produce the monomeric organic peroxide. A tetrameric form has also been described, under different catalytic conditions, albeit not without disputes and controversy. The most common route for nearly pure TATP is H2O2/acetone/HCl in 1:1:0.25 molar ratios, using 30% hydrogen peroxide. This product contains very little or none of DADP with some very small traces of chlorinated compounds. Product that contains large fraction of DADP can be obtained from 50% H2O2 using large amounts of concentrated sulfuric acid as catalyst or alternatively with 30% H2O2 and massive amounts of HCl as a catalyst. The product made by using hydrochloric acid is regarded as more stable than the one made using sulfuric acid. It is known that traces of sulfuric acid trapped inside the formed acetone peroxide crystals lead to instability. In fact, the trapped sulfuric acid can induce detonation at temperatures as low as 50 °C (122 °F). This is the most likely mechanism behind accidental explosions of acetone peroxide that occur during drying on heated surfaces. Organic peroxides in general are sensitive, dangerous explosives, and all forms of acetone peroxide are sensitive to initiation.
== Structure == The activin and inhibin protein complexes are both dimeric in structure, and, in each complex, the two monomers are linked to one another by a single disulfide bond. In addition, both complexes are derived from the same family of related genes and proteins but differ in their subunit composition. Below is a list of the most common inhibin and activin complexes and their subunit composition:
Sources: en.wikipedia.org
Eggshells, snail shells and most seashells are predominantly calcium carbonate and can be used as industrial sources of that chemical. Oyster shells have experienced recognition as a source of dietary calcium since the early 2010s, but also remain a practical industrial source. Dark green vegetables such as broccoli and kale contain dietarily significant amounts of calcium carbonate, but they not practical as an industrial source. Annelids in the family Lumbricidae, earthworms, possess a regionalization of the digestive track called calciferous glands, Kalkdrüsen, or glandes de Morren, that processes calcium and CO2 into calcium carbonate, which is later excreted into the dirt. The function of these glands is unknown but is believed to serve as a CO2 regulation mechanism within the animals' tissues. This process is ecologically significant, stabilizing the pH of acid soils.
=== Blood tests === In someone suspected of having cholecystitis, blood tests are performed for markers of inflammation (e.g. complete blood count, C-reactive protein), as well as bilirubin levels in order to assess for bile duct blockage. Complete blood count typically shows an increased white blood count (12,000–15,000/mcL). C-reactive protein is usually elevated although not commonly measured in the United States. Bilirubin levels are often mildly elevated (1–4 mg/dL). If bilirubin levels are more significantly elevated, alternate or additional diagnoses should be considered such as gallstone blocking the common bile duct (common bile duct stone). Less commonly, blood aminotransferases are elevated. The degree of elevation of these laboratory values may depend on the degree of inflammation of the gallbladder.
==== Non-nucleoside phosphoramidites ==== Non-nucleoside phosphoramidites are the phosphoramidite reagents designed to introduce various functionalities at the termini of synthetic oligonucleotides or between nucleotide residues in the middle of the sequence. In order to be introduced inside the sequence, a non-nucleosidic modifier has to possess at least two hydroxy groups, one of which is often protected with the DMT group while the other bears the reactive phosphoramidite moiety. Non-nucleosidic phosphoramidites are used to introduce desired groups that are not available in natural nucleosides or that can be introduced more readily using simpler chemical designs. A very short selection of commercial phosphoramidite reagents is shown in Scheme for the demonstration of the available structural and functional diversity. These reagents serve for the attachment of 5'-terminal phosphate (1), NH2 (2), SH (3), aldehydo (4), and carboxylic groups (5), CC triple bonds (6), non-radioactive labels and quenchers (exemplified by 6-FAM amidite 7 for the attachment of fluorescein and dabcyl amidite 8, respectively), hydrophilic and hydrophobic modifiers (exemplified by hexaethyleneglycol amidite 9 and cholesterol amidite 10, respectively), and biotin amidite 11.
The 2013 annual aggregate manufacturing quota is 250 kilos. International treaties and the controlled-substances laws of most countries, such as the German Betäubungsmittelgesetz, regulate dihydrocodeine at the same level as codeine. Dihydrocodeine-based pharmaceuticals are especially used where chronic pain patients are able to have essentially OTC access to them provided they are registered with the provincial or national government as such a patient. Controlled-release dihydrocodeine is a non-prescription item in some places, especially the 60 mg strength. A report by the Ivo Šandor Organisation in 2004 listed Andorra, Spain, Gibraltar and Austria as having varying degrees of access to these and other dihydrocodeine, nicocodeine and codeine products.
Sources: en.wikipedia.org
Reversed-phase high-performance liquid chromatography is the standard method, with detection in the ultraviolet range. Peak area percentage yields a purity figure for the main component. Mass spectrometry is normally run alongside to confirm molecular identity.
Dry lyophilised powder is generally kept at minus twenty degrees Celsius, protected from light and moisture. Repeated freeze-thaw cycles are avoided because they encourage aggregation and moisture uptake. Solutions are less stable than the solid form and degrade faster at room temperature.
A certificate documents what the supplier measured, not what an independent party confirmed. Methods, instruments and acceptance criteria can differ between suppliers. Third-party testing is the usual way to resolve discrepancies.
It originated at the Institute of Molecular Genetics in Moscow during the 1980s. The work was carried out by a Russian research group that specialized in peptide neuropharmacology.